Contact

Wall bend fixture

Wall bend fixture for bending and securing pipe-in-pipe in walls with framing from 70 mm. 

Wall bend fixture in packages
Thermotech wall bend fixture is used for bending and securing pipe-in-pipe in walls with framing from 70 mm. It can be installed in fixture plate or attachment plate.

Thermotech MultiSystem™ wall bend fixture can be ordered in packages with 1, 2 or 5 fixtures and all necessary accessories included.

The wall bend fixture can be easily installed in fixture plates for correct c/c di­mensions between the connections. If the wall bend fixture is installed from the rear in plywood, it is secured with an attachment plate.

The fixture is made for installation in walls with board ma­terials in two layers (such as wet room walls in compliance with the regulations of the Swedish heating, water and sanitation industry, with 15-mm construction plywood and wet room sheeting) but can also be cut to work in walls with common plaster.

A wall bend fixture with several good properties

  • S-radius – Maximised bend radius entailing less load on the protective tubing
  • Ergonomic grip
  • Adapted for the wall construction as prescribed by the regulations of the Swedish heating, water and sanitation industry
  • Robust construction
  • No attachment flashing on front
  • Can be turned in the attachment plate
  • No moving parts
Väggbockfixtur

In the box